Connecting The Speakers - Kenwood VR Series Instruction Manual

Connecting the speakers
VRyKflF-V SERIES (En/KM)
Front Speakers A
Right Left
O
Center Speaker
KRF-V6020
Except lor The KRF-
V6020 is equipped with
one-touch speaker ter¬
minals. They are arranged
in the same manner as
the speaker terminal s of
the KRF-6020. Refer to
the instructions on
making cor>nections to
the KRF-6020 when
making connections to
theVR-306/VR-305/VR-
355 and KRF-V5020.
B □ 0
Except for KRF-V6020
Use the FRONT
SPEAKERSB
terminala if you
want to connect a
second front
speaker system.
(VR-306, VRO05,
VR-355 and KRF-
Powered ''"f® "Jl
subwoofer «<«*PP«<wlth
SPEAKERSB
terminal.)
♦
0
- •
0
'^
•IMWOIMD •»KAKin«
Right Left
Surround Speakers
(Be sure to connect both
surround soeakers^
* Never short circuit the + and - speaker cords.
♦ If the left and right speakers are connected inversely or the speaker
cords are connected with reversed polarity, the sound will be
unnatural with ambiguous acoustic imaging. Be sure to connect
the speakers correctly.
Speaker impedance
After confirming the speaker impedance indications printed on the
rear panel of the receiver, connect speakers with matching imped¬
ance ratings. Using speakers with a rated impedance other than that
indicated on the rear panel of the receiver couid result in malfunctions
or damage to the speakers or receiver.
FRONT SPEAKERS.8-16 Q
CENTER SPEAKER.8-16 Q
SURROUND SPEAKERS.8-16 Q
PRE OUT connections
This receiver has additional preout jacks. These can be used for
various purposes, but witi need to be connected to an external power
amplifier as shown in the example below.
□O
SpMlwra
Powared
• The VR-305. VR-306, VR-355 and KRF*V5020 is equipped with a
SUBWOOFER terminal only.
• Connecting a speaker cord directly to a PRE OUT jack will not
produce any sound from the speaker. -
• To use the PRE OUT jacks, press the
SPEAKERS A
key to the on
position (the
SPEAKERS
key in the case of the VR'305, VR-306, VR-
355 and KRF-V5020)