High Filter - Kenwood KA-5200 Instruction Manual

BALANCE control
This BALANCE adjusts unequal volume from any program
source
in right and left channels,
The left channel
is accen-
tuated when this adjuster is turned trom center "5" toward
the left side, and conversely.
VOLUME control
The VOLUME control performs simultaneous adjustment
of volumes in both channels (right and left}, Set it to your
own most satisfactory listening level.
TAPE MONITOR switches
(A and B)
The TAPE MONITOR switch-
es are used when operating a
tape recorder for monitoring
a recording or for tape repro-
duction. With the button
Pushed in, sound recorded on
the tape is heard. When the
button is released, the source
signals is heard.
If a tape recorder connected
to the A TAPE jacks on
the rear panel is used, the
TAPE MONITOR A must be
switched on. When the TAPE
MONITOR B is pressed, the
tape recorder connected to
the B TAPE jacks on the
front panel becomes availa-
ble.
The TAPE MONITOR switch-
es should be kept switched
off (by button release) unless
monitoring or tape reproduc-
tion is performed
FM MUTING switch
This switch silences intersta-
tion noise on the FM band,
but it may also eliminate the
signal of a weak and distant
station along with the inter-
station noise. Therefore, set
this switch ta OFF {by press-
ing button release} in the re-
ception of a weak and distant
station.
LOUDNESS control
The LOUDNESS control
boosts bass and treble tones
at low listening levels. Our
ears have less sensitivity to
low and high frequencies at
low listening levels and the
LOUDNESS control com-
pensates for this deficien-
cy. This control should be
switched off when listening
at normal and high levels.
LOW and HIGH FILTER
switches
LOW FILTER — Pressing
this button switch reduces
low frequency noise such as
turntable rumble, hum, etc,
on pragram materials. Gen-
erally, this filter should be
used anly when necessary
HIGH FILTER — Pressing
this button switch reduces
high frequency noise suchas
tape hiss, record scratch, etc.
Generally, this switch should
be used only when necessary. ;
SELECTOR switch TUNING knob
The TUNING knob selects
the desired AM or FM station
signal. Adjust it for maximum
deflection of the TUNING
meter as you listen to the
sound output from the speak-
ers
Switch positions and func-
tions are as follows:
AM — For AM reception
FM For the reception of
both FM monaural and stereo
signals. Automatic switching
operates between FM mon-
aural and stereo sources.
When an FM stereo broadcast
is tuned in, the STEREO in-
dicator lights up.
PHONO — in this position
the record player is available
if connected to the PHONO |!
input Jacks on the rear panel !
AUX 1. Selects source con-
nected to the AUX 1 jacks
AUX 2 — Selects source con-
nected to the AUX 2 jacks
MIC — In this position the
microphone is available if
connected to the MIC jack