Table of Contents
Advertisement
CD/External disc control features
Presetting Disc Names
Store the names of discs to be displayed when played.
1 Play the disc whose name you want to preset.
¢ This function is not available for disc changers that do not
feature the Disc Name Preset function.
* This procedure is not to be used to store the disc and track titles
for MDs that you record.
2 Press the NAME.S button for at least two seconds.
"NAME SET" ts displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
3 Press either the K< or BPI button to move the cursor to the
desired position.
The <4 button moves the cursor to the left, and the >
button to the right.
You can also move the cursor left or right by pressing the
TRACK+ or TRACK- buttons, respectively, on the remote
control.
4 Each time the mI button is pressed, the characters to be
entered change as listed below.
Press the DISC+ or DISC— button to display the desired
character.
Characters that van be displayed are as follows.
Alphabet (upper case): A ~ Z
Vv
Alphabet (lower case): a ~ z (KDC-601 1/5011 Only)
v
Numerals and symbols: 1~90
@""*
% &*+-=,
/\<>f]
Sparinlicharactare Saéei
i6S5UNAHCSRiVsae
Grissa0R
3 sii
(KDC-601 1/5011 Only)
as listed below, depending on the unit that is connected.
A press of the ® 1 button exits the disc name preset mode.
Operations can be followed again from Step 2 at a time such
as this, and the characters to be input are eelpeted. using the
procedure described below.
Press the DISC+ or DISC— button to display the desired
character. Besides the alphabet (capital letters only) and
numbers, you can choose the following characters: /, +, —, *,
_<, >, [and].
5 Continue steps 3 and 4 until all the characters are chosen for
the name.
6 Press either the NAME.S button on the main unit or the OK
button on the remote.
The disc name is stored and the disc name preset mode is
canceled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
* The number of characters and discs whose names can be
stored will differ depending on the disc changer that is
connected. Please see your disc changer manual for details.
Up to 8 characters and 10 CDs can be registered with this unit.
* Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.
¢ lf you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
* Pressing the reset button erases the disc names stored in this
unit, but does not erase names stored in a disc changer.
—24—
Advertisement
Table of Contents
