Table of Contents
Advertisement
cord and make sure that all other cables are disconnected. Moving the printer without doing so
could damage the power cord or the cables and cause a fire or electric shock.
• Two persons standing at the front and back of the printer
must lift the printer while holding the left and right handles
provided at the bottom of the printer. If you lift the printer in
an unnatural posture, you may drop it, resulting in an injury.
In addition, if you hold the feeder lift tray or auto stacker, you
may damage it or drop the printer, resulting in an injury.
• Always hold the printer level and carry it slowly. If ink is spilled inside the printer while moving it,
this could cause a fire or serious electric shock or damage the printer.
• Before moving or shipping the printer, be sure to execute [Preparation for Moving the Printer] or
[Preparation for Transporting the Printer] from the printer driver. Also when shipping the printer,
set the protectors.
Moving or shipping the printer without taking necessary measures could cause ink leak inside the
printer, resulting in a fire, electric shock, or printer failure.
Important
• To prevent machine failures, do not relocate or transport this printer with the upper unit open.
Maintenance and Inspections
■
Warning
• To avoid a fire hazard, occasionally disconnect the power cord from the printer and the power
supply and use a soft dry cloth to clean the cord connectors and the connection points. Leaving
the cord plugged in and not cleaned for a long period, especially in an area subject to dust, oil, and
high humidity, could cause the insulation material to deteriorate.
• When cleaning the printer, do not use a flammable solvent (alcohol, thinner, etc.). If a flammable
solvent is brought into contact with the parts inside the printer, a fire or electric shock could result.
• Check the power cord and power plug regularly. If the following conditions occur, contact your
place of purchase, as the condition may cause a fire:
– There are burn marks on the power plug.
– The blade on the power plug is deformed or broken.
– The power goes OFF and ON when the power cord is bent.
– There are cuts, cracks, or indentations on the power cord.
Important Safety Instructions
8
Advertisement
Table of Contents
