Table of Contents
Advertisement
Figure 45
1. Adjustment rod
6.
Looking down towards the adjustment rod —
rotate it counterclockwise, in 1/4 turn increments,
to increase speed or clockwise to decrease
speed.
7.
Drive the machine and check the full forward
tracking.
8.
Repeat steps
5
through
is obtained.
Check Transmission Mount
Bolt Torque
Service Interval: After the first 5 hours
Yearly thereafter
Torque the 4 transmission bolts to 56-69 N-m (41-51
ft-lb); refer to
Figure
46.
Note:
Do Not use anti-seize compound on the wheel
hub.
Figure 46
1. Transmission bolts
g233418
7
until desired tracking
g233601
Brake Maintenance
Adjusting the Parking
Brake
If the parking brake does not hold securely, an
adjustment is required.
1.
Refer to
Preparing for Maintenance (page
2.
Check the air pressure in the drive tires. If
needed, adjust to the recommended inflation;
refer to
Checking the Drive Tire Air Pressure
(page
37).
3.
Disengage the parking brake.
4.
Loosen the cable clamp on the brake cables
under the console
5.
Adjust both cable conduits downward
approximately 1/8 to 1/4 inch (3 to 6 mm).
1. Cable clamp
6.
Tighten the cable clamp and engage the parking
brake.
7.
Check the parking brake; repeat steps
6
if necessary.
39
(Figure
47).
Figure 47
4
30).
g233407
through
Advertisement
Table of Contents
