Adjust The Volume Balance - Kenwood KR-V5560 Instruction Manual

eek ; This mode provides a similar Dolby Surround effect used in movie theaters when a video (or LD) software programe carrying th=
20° TX [pour smo] mark is played.
ecsilee
Teeter atatehiat ey
ert coaic
Each press of the CENTER MODE key switches the center modes as
: follows:
@ Select the center mode using a | @ NORMAL _ : When the center speaker is a compact-sized spe.
ae object (such as a bail-point (2) WIDEBAND : When the center speaker is a mecium- or large-
speaker.
@ PHANTOM °: When the center speaker is not used.
e If you cannot tell whether your center speaker is compact or mc
dium-sized, try two modes and select according to your liking.
e@ The selected center mode is automatically stored in memory anc
held unless it is changed later.
ESE OSE EO SE SS OF PEP OO OEE Oe CPE SP SE ee errr Peers TPP ere eee rs eer PE SEP eraser ESOP er eer ee eer rece Se erere errr eee saree
# The test tone which is heard like noise moves between speakers ai
2 Adjust the volume balance. an interval of 1.5 sec.
@ Generate the test tone. :
TESTTONE
InNORMALandWIDEBAND — In PHANTOM meade;
modes:
Left (L) a re Left {L)
: 3 E Center (C} Right (R}
@ Align the speaker volumes with the | Right (R) Surround (Rear) (S)
main speaker volume. E
Center speaker To increase Surround (Rear) (S)
S 25 ay —
ex i. F- 4
VIDEO a
Rear speakers
To decrease
Yo
=u
i [5
/ {_
'~@ Stop the test tone.
Se e@ Be sure to adjust from your listening position.
e When a key is pressed, the corresponding volume !evel to the key is
displayed on the display. While the level is displayed, it can be acd
4 justed by 1 dB per press of the key.
E e The volume levels can be adjusted in the_range from -10 dB to +1C
MULTI LEVEL CONTROL id e When the DELAY TIME key 's pressed, the delay time is displayed
a on the display.
e The delay time can be adjusted in the range from 15 ms to 30 ms, in
5S ms steps.
@ Set the closest value to the value obtained with method (1) or (2)
below.
@ Once the delay time has been preset, it is held until it is re-set later.
PePerPSESSOeS USES EST SURO CeULeCOLirerreeterirece cere ser sr ret te ise se cee ce Sete See ee eee reset err ee ee
-
ay tim
Assuming that the distance from the front speaker is A
meters and the distance from the rear speakers is B FE
meters. § B=3m, the delay time
E is 20 ms.
Example: When & = 3 m,
(2) Use the following formula for calculation.
Delay time = 20 + 3x (A- B) (Unit; ms)
ee