App Guide; Charger Usage - Huawei FusionCharge AC User Manual

5
Connecting Communications
Cables
If you use WiFi connection, ensure that the
installation area is within the coverage.
If you select wired connection, refer to the
following to connect communications cables.
In the following figure, the power cable is routed
in from the middle.
1. Seal unused power cable holes with rubber plugs.
2. Cut the cable rubber cover based on site
requirements and secure it to the communications
cable inlet.
3. Route the network cable through the left
cable hole at the lower part of the rear cover.
4. Connect the network cable to the FE port on
the rear side of the charger.
1 1
2
FE
1
4
3
x 3 x 1
12
6
Completing the Installation
In the following figure, the power cable is
routed in from the middle and WiFi networking
is used.
1. Seal unused power cable holes with rubber
plugs.
2. Align the charger with its rear cover, and push
the charger downwards.
3. Tighten the screws at the bottom. (Use a TT20
insulated security torx torque screwdriver with
a torque of 2.0 N·m.)
2 1
"CLICK!"
Router
1
x 4
App Installation
Scan the device's QR code before operating.
Download and install the latest app on your
smartphone.
Follow the instructions on the app to complete
wizard settings and parameter settings.
1
App Operation Guide
3
Scan the QR code to obtain the
app operation guide.

Charger Usage

Read the installation precautions before using the product.
Ensure that the charger is not cracked or damaged.
Ensure that there is no liquid or other foreign matter on
the charging connector or inside the charging port of the
vehicle.
The following shows how to start a charging session by
swiping the card. For details about other charging modes,
see the charger app.
If the plug-and-play charging mode is used, you can stop
a charging session from the vehicle, by RFID card swiping,
or on the charger app.
Charging by Card Swiping
1. Open the vehicle's charging port.
2. Take the charging connector,
open the socket cover, and
properly insert the charging
connector into the charger and ≤120°
vehicle.
3. Place the RFID card in the
swiping area to start a
charging session. Keep the
ring pattern on the card
in the swiping area. If the
indicator fast flashes blue
for three times, the card
swiping is successful.
Stopping Charging
Swipe the RFID card to stop a charging session.
Charging will automatically stop when the battery is full.
If the indicator fast flashes red for three times, scan the
QR code in "About This Document" and refer to
"Troubleshooting."
13