Philips PM 5775 Manual page 4

ST OF FIGURES
IV-1
IV-2
V-1
V-2
V-3
V-4
VI-1
VI-2
VI-3
VI4
VI-5
VI-6
VI-7
VIi-1
VH-2
VII-3
VII-4
VII-5
VII-6
VIH-1
VII-2
VIII-3
VIII-4
VIU-S
VIII-6
X-1
X-2
X-3
X-4
X-5
X-6
XI-1
XI-2
XI-3
XI-4
XI-5
XI-6
Waveforms
Block diagram
Indication of controls, input/output sockets at the front of PM 5776
Indication of controls, input sockets at the rear of PM 5776
Indication of controls, input/output sockets at the front of PM 5775
Indication of controls, input sockets at the rear of PM 5775
PHILIPS sampling oscilloscope PM 3400
Time settings at single-pulse operation
Set-up monitoring the output pulse of PM 5775
Set-up monitoring the simultaneous output pulse of PM 5776
Interaction of positive-going and negative-going pulses at normal
and inverted pulse operation
Time settings at double-pulse operation
Time settings at gated-pulse operation
Simplified diagram of the pulse delay trigger circuit
Simplified diagram of the pulse delay circuit
Simplified diagram of the pulse width trigger circuit
Simplified diagram of the driver and output stage
Simplified diagram of the driver and output stage with fine control
circuit
Simplified diagram of the current source for the positive output
pulse
Tilting assembly
Removing the knobs
Removing the transparent cap of the POWER ON switch
Removing the output unit (printed wiring board PM 5775-3)
Removing reed-relay coils L320, L321
Applying of the silicone compound
Set-up for checking the gate circuit
Set-up for checking the astable multivibrator
Pulse diagram for 5 ns delay adjustment
Pulse diagram
Pulse diagram
Pulse diagram
Location of components (front)
Location of components (rear)
Tilting assembly
Location of components (interieur)
Cropping transistor leads
Winding data for L304 and L317