The Remote Control Unit; For More Accurate Editing - JVC GR-DVL100U Manual

Random Assemble
Editing Menu
Us THE REMOTE CONTROL UNIT (con
For More Accurate Editing
Some VCRs make the transition from Record-Pause to
Record mode faster than others. Even if you begin editing
for the camcorder and the VCR at exactly the same time,
you may lose scenes you wanted, or find that you have
recorded scenes you did not want, For a cleanly edited
tape, confirm and adjust the timing of the camcorder
against your VCR.
DIAGNOSING VCR/CAMCORDER TIMING
1 Play back the tape in the camcorder, then point the
remote control at the camcorder's remote sensor and
press R.A.EDIT ON/OFF.
'The Random Assemble Editing Menu appears.
Bp] Perform Random Assemble Editing on Program 1
4 only. In order to check VCR and camcorder timing,
select the beginning of a scene transition as your Edit-
In point.
4] Pay back the dubbed scene.
FY + if any images from the scene prior to the
transition you chose for your Edit-In point were
recorded, that means your VCR moves too quickly
from Record-Pause to Record mode.
'Ifthe scene you tried to dub starts in progress, the
VCR is slow to start recording.
MENU/BRIGHT Dial
ADJUSTMENT OF VCR/CAMCORDER
TIMING
Point the remote control at the camcorder's remote
sensor and press R.A.EDIT ON/OFF to make the
Random Assemble E d i t i n g menu disappear, then
press the MENU/BRIGHT wheel. The Menu Screen,
appears.
fay Rotate the MENU/BRIGHT wheel to select "BEI" and
FOB press it. "VIDEO MENU" appears. Then, rotate it to
*SYNCHRO" and press it. The value for "SYNCHRO"
is highlighted.
[A bss on the diagnostics performed (7 pg. 48), you
can now advance the VCR's record timing by rotating
the MENU/BRIGHT wheel towards "+". You can also
delay the VCR's record timing by rotating the MENU/
BRIGHT wheel towards "-". The adjustment range is
from =1.3 to +1.3 seconds, in 0.1-second increments.
Press the MENU/BRIGHT wheel to finish the setting.
Rotate the MENU/BRIGHT wheel to select
"RETURN" and press it twice.
Now perform Random Assemble Editing beginning
with step 4 on page 46.
NOTES:
© Before performing actual Random Assemble Editing, do
a few Random Assemble Editing trial runs to check
whether the value you have input is appropriate or not,
and make adjustments accordingly.
© Depending on the recorder, there may be situations
where the timing difference cannot be fully corrected.