Configuring The Ip Address Of The Management Client; Logging In To The Web Page - Ruijie Reyee RG-RAP52-OD Configuration Manual

Web-based Configuration Guide
1.3.2

Configuring the IP Address of the Management Client

Configure an IP address for the management client in the same network segment as the default IP address of
the device (The default device IP address is 10.44.77.254, and the subnet mask is 255.255.255.0.) so that the
management client can access the device. For example, set the IP address of the management client to
10.44.77.100.
Caution

Make sure that the client can access the Eweb system as long as it can ping the access point.

The IP address of the management client cannot be set to 10.44.77.253, because this IP address is
reserved by the device. If the management client uses this IP address, it cannot access the device.
1.3.3

Logging in to the Web Page

(1) Enter the IP address (10.44.77.254 by default) of the access point in the address bar of the browser to open
the login page.
Note
If the static IP address of the device is changed, or the device obtains a new dynamic IP address, the new IP
address can be used to access the web management system of the device as long as the management client
and the device are in the same network segment of a LAN.
(2) On the web page, enter the password and click Log In to enter the web management system.
You can use the default password admin to log in to the device for the first time. For security purposes, you
are advised to change the default password as soon as possible after logging in, and to regularly update
your password thereafter.
If you forget the IP address or password, hold down the Reset button on the device panel for more than 5
seconds when the device is connected to the power supply to restore factory settings. After restoration, you
can use the default IP address and password to log in.
2
Fast Internet Access