Remove The Game Controller - Lenovo Legion Go 8APU1 Hardware Maintenance Manual

3. Follow the correct sequence in the steps for removing a FRU, as shown in the illustrations by the
numbers in square callouts.
4. When removing a FRU, move it in the direction as shown by the arrow in the illustration.
5. To install a new FRU in place, perform the removal procedure in reverse and follow any notes that
pertain to replacement.
6. When replacing a FRU, carefully retain and reuse all screws.
7. When replacing the base cover, reapply all labels that come with the replacement base cover. If some
original labels are not included with the replacement base cover, peal them off from the original base
cover and paste them on the replacement base cover.
DANGER
Before removing any FRU or CRU, shut down the device and unplug all power cords from electrical
outlets.
Attention: After replacing a FRU, do not turn on the device until you have ensured that all screws, springs,
and other small parts are in place and none are loose inside the device. Verify this by shaking the device
gently and listening for rattling sounds. Metallic parts or metal flakes can cause electrical short circuits.
Attention: The system board is sensitive to and can be damaged by ESD. Before touching it, establish
personal grounding by touching a ground point with one hand or by using an ESD strap (P/N 6405959).

Remove the game controller

Step 1. Press the button and slide down to remove the left and right game controllers.
Figure 2. Remove the game controller
Go to
https://support.lenovo.com/partslookup
part:
Game controller
26
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement