Pioneer MJ-L7 Service Manual page 42

MJ-L7
6.2.6 TEST REC Mode
Setting Method Remarks Display
Test mode STOP state [ tom A Aes &]
Press the CHARACTOR button TEST REC menu [ TEST REC ]
of DISPLAY unit twice
Press the REC MODE button Recording start address setting (cluster) [ ad032PWVV |
Press the PLAY/PAUSE button Continuous recording (Groove part) [al PWVV ]
Press the STOP button of the Unit | TEST REC menu [ TEST REC ]
e : Address (Cluster), VV: Laser recording power
@ When the STOP button of the Unit is pressed during the TEST REC menu, the test mode STOP state will be set.
@ Press the <<, >» buttons of the Unit to change the settings at step 3.
* wb button: Set the address to +01H.
* «d<d button: Set the address to -O1H.
@ When the +, — buttons of DISPLAY unit is pressed in the address setting state or continuous recording state, the laser recording power will
change.
6.2.7 INNER Mode (Read In SW Detection)
Setting Method Remarks Display
Test mode STOP state | | [ SMM A ACH &]
Press the REC button | INNER mode menu display | [INNER ]
Press the PLAY/PAUSE button INNER switch position address display [ SODOOCAAAA |
Step 4 Press the STOP button of the Unit | INNER mode menu display [ INNER ]
OO00: Address (Cluster), AAAA: Cl error
When the STOP button of the Unit is pressed during the INNER menu, the test mode STOP state will be set.
Perform when replacing the MD MECHA SW ASSY.
Perform using the high reflective disc. The unit will not operate on the low reflective disc.
6.2.8 EJECT State
Setting Method Remarks Display
Eject the disc EJECT mode menu display [ EJECT ]
Press the REC MODE button Laser power switching [ rPw ]
Press the REC button EEPROM setting mode (CONTROL setting) [ pPw ]
Press the CHARACTOR button EEPROM setting mode (TEMP setting)
of DISPLAY unit
@ Refer to "6.2.4 EEPROM Setting Mode" for details on the EEPROM setting mode.
42