Calibrating Foot Pod; Calibrating Power Pod - Suunto SPARTAN SPORT WRIST HR 1.9 User Manual

Suunto Spartan Sport Wrist HR
NOTE: You cannot pair anything if airplane mode is on. Turn off airplane mode before
pairing. See 3.2. Airplane mode.
To pair a POD or sensor:
1. Go to your watch settings and select Connectivity.
2. Select Pair sensor to get the list of sensor types.
3. Swipe down to see the whole list and tap on the sensor type you want to pair.
4. Follow the instructions in the watch to complete pairing (refer to sensor or POD manual if
needed), pressing the middle button to advance to the next step.
If the POD has required settings, such as crank length for a power POD, you are prompted to
enter a value during the pairing process.
Once the POD or sensor is paired, your watch searches for it as soon as you select a sport
mode that uses that sensor type.
You can see the full list of paired devices in your watch from the settings under Connectivity »
Paired devices.
From this list, you can remove (unpair) the device if needed. Select the device you want to
remove, and tap Forget.

3.22.1. Calibrating foot POD

If you have paired a foot POD, your watch automatically calibrates the POD using GPS.
For the first calibration, you should select a sport mode where the foot POD is used and the
GPS accuracy is set to Best. Start the recording and run at a steady pace on a level surface, if
possible, for at least 15 minutes.
Run at your normal average pace for the initial calibration, and then stop the exercise
recording. The next time you use the foot POD, the calibration is ready.
Your watch automatically re-calibrates the foot POD as needed whenever GPS speed is
available.

3.22.2. Calibrating power POD

For power PODs (power meters), you need to initiate the calibration from the sport mode
options in your watch.
To calibrate a power POD:
1. Pair a power POD with your watch if you have not done so already.
2. Select a sport mode that uses a power POD and then open the mode options.
26