Fault In The Autodos (Automatic Dispensing) - Miele G7966SCVI Operating Instructions Manual

Fault in the AutoDos (automatic dispensing)

Problem
The following message
appears on the display:
Insert PowerDisk or deacti-
vate AutoDos with OK.
The in-operation indica-
tor light is flashing
quickly.
The alarm tone is
sounding.
The program does not
start or a program that
has already started
stops.
The following message
appears on the display:
AutoDos lid open
The following message
appears on the display:
PowerDisk empty. Deacti-
vate AutoDos with OK.
The message
PowerDisk empty. Deacti-
vate AutoDos with OK.
pears in the display
even though you have
inserted a new Pow-
erDisk.
Possible cause and solution
The AutoDos function is active but no PowerDisk has
been inserted.
 Insert a PowerDisk (see "Automatic dispensing/
AutoDos" under "Detergent").
 If you do not wish to use AutoDos, deactivate the
function using OK.
The AutoDos lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see "Auto-
matic dispensing/AutoDos" under "Detergent").
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see "Inserting a
PowerDisk" under "Detergent").
 If the same fault message appears again, contact
Miele Technical Service.
The AutoDos function is active and the PowerDisk is
empty.
 Replace the PowerDisk (see "Automatic dispens-
ing/AutoDos" under "Detergent").
If you do not wish to use AutoDos, deactivate the
function using OK.
The dishwasher was turned off when the PowerDisk
was replaced and it has therefore not recognized the
ap- new PowerDisk.
 Turn the dishwasher on before replacing the Pow-
erDisk (see "Automatic dispensing/AutoDos" and
"Inserting a PowerDisk" under "Detergent").
Frequently asked questions
103