Table of Contents
Advertisement
Option
Entry Unit
Base Heater
Cautions for base heater and control box
•
If the main software version of the Outdoor unit is prior
to August 2018, Base Heater setup is unavailable. Update
the firmware for your Main PBA(DB92-03752A)
•
If the option is not set, an error occurs so normal
operation may not be possible.
•
To obtain the updated outdoor unit firmware, please
reach out to your local Samsung HVAC service or
distribution center.
※ When ODU is working on "Base Heater testing mode", or
In normal "base heater working" condition, never touch
the heater or a part near the base plate. It may cause
serious burns.
※ When checking for proper functionality of the base heater,
use a suitable non-contact thermometer.
Test running the base heater
[DVM S Series]
DB68-12029A-00_IM_ACC BASE HEATER Control KIT_AA_EN.indd 13
SEG1
SEG2
Main
2
3
SEG3
SEG4
0
0
Disabled (Factory default)
0
1
[DVM S2 Series]
After the installation, test run the outdoor unit by using
the tact switch.
Test run procedure
1
Test run the base heater by using the K2 button.
•
Press the K2 button 14 times to display the following.
2
Check whether the control box relay operates properly.
3
Check whether the surface temperature of the base
heater has increased.
•
Be sure to use a non-contact thermometer when
checking the temperature.
CAUTION
•
Do not touch base pan heater as it may cause serious
burns.
4
The test run finishes after 3 minutes.
Function
Enabled
English
13
2022-09-06 오전 11:43:24
Advertisement
Table of Contents
