Maintenance; Cleaning The Mesh Filter - Samsung FT-MF User Manual

Maintenance

Cleaning the mesh filter

Clean the mesh filter when the Filter status indicator blinks.
CAUTION
For the safety, turn off the Microfiber filter and the washing machine
connected to it before removing the mesh filter.
1. Turn off the Microfiber filter and the washing machine connected
to it.
2. Hold the mesh filter handle and turn it counterclockwise. Then,
pull out to remove the mesh filter from the main unit.
CAUTION
Be careful when removing the mesh filter because there may be
undrained water inside.
A
3. Separate the mesh filter and the handle.
- Hold the part (A) of the handle. Then turn the mesh filter in
the direction of the arrow (as shown in the figure).
4. Clean the waste collected in the mesh filter using a soft brush.
- Make sure to discard the collected waste into the waste bin.
5. Assemble the mesh filter and the handle.
6. Insert the cleaned mesh filter back into the main unit, and then
turn it clockwise until the mark on the handle is pointing up.
7. Press and hold the Filter Reset button for 3 seconds to reset the
status of the mesh filter.
DC68-04471B-00_IB_FT-MF_EU_EN_DE_NL_FR_IT_ES_PT_DA_FI_NO_SV_PL_HU_EL_RO_BG_LT_LV_ET_CS_SK_HR_TR.indb 9
CAUTION
• If the mesh filter is damaged, performance may degrade, or a
drain error message may appear on your washing machine.
• If the Filter status indicator keeps blinking after resetting the
filter, check if you have properly inserted the mesh filter.
• If the mesh filter is not inserted in the correct position, water
may leak or performance may degrade. Furthermore, a drain
error message may appear on your washing machine.
CAUTION
To continue using the Microfiber filter in an environmentally friendly
way, avoid using water to clean the mesh filter. Instead, discard the
collected waste in a waste bin.
Defrosting the Microfiber filter
Any water remaining inside the Microfiber filter may freeze when the
temperature drops below 0 °C.
1. Turn off the Microfiber filter, and unplug the power cord.
2. Disconnect the two hoses connected to the Microfiber filter and
soak them in warm water.
3. Detach the Microfiber filter from the cradle, and put it on a tray
or a container. Then, move it to a warm place to defrost frozen
water.
4. Mount the Microfiber filter onto the cradle, and connect the
hoses back to it.
NOTE
If the Microfiber filter still doesn't operate normally, repeat the above
steps until it operates normally.
English 9
2023-06-07 5:52:11