Travel Speed Selector Switch (Selection Switch) - Komatsu GALEO PC1250-8 Operation & Maintenance Manual

OPERATION

Travel Speed Selector Switch (Selection Switch)

When loading or unloading from a trailer, always travel at low speed (with travel speed selector switch (3) at the Lo position).
Never operate travel speed selector switch (3) while loading or unloading.
If the travel speed is switched between Hi and Lo when the machine is traveling, the machine may deviate to one side, even
when traveling in a straight line.
Stop the machine before switching the travel speed.
This switch (3) is used to set the travel speed to 2 stages.
Lo lights up : Low-speed travel
Hi lights up : Hi-speed travel
When the engine is started, the speed is automatically set to Lo.
Each time that the switch is pressed, the display changes Lo !
Hi ! Lo in turn.
When traveling in high speed (Hi), if travel power is needed, such as when traveling on soft ground or on slopes,
the speed automatically switches to low speed (Lo), so there is no need to operate the switch. The monitor display
stays at Hi.
REMARK
Each time that the travel speed selector switch is operated, the
mode is displayed in the center of display portion (GG), and the
screen returns to standard screen (BB) after 2 seconds.
WARNING
DETAILED CONTROLS AND GAUGES
3 - 23