Husqvarna HG 125 B Original Instructions Manual page 19

Masonry Cutting Guard
Assembly
for all tool operations. Do not discard
guard when not in use. Always reinstall
wheel guard when converting back to
grinding operations.
To improve ergonomics of your grinder
when cutting masonry, gearbox must be
rotated relative to the position of the switch
as the tool was assembled at the factory.
ROTATE GEARBOX (Fig. 9)
1. Disconnect battery pack from tool.
2. Completely unscrew the four screws
between the gear housing and motor
body.
3. Rotate gear housing to the proper
orientation without removing motor from
the housing.
For the slide switch models, rotate gear
housing 180 degrees in the direction
indicated in Fig 10, so the switch is 90
degrees from the spindle.
4. Screw in and tighten the four screws you
removed.
5. The screw holding the guard release lever
is longer than the other screws, this long
screw must stay with the guard release
lever when re-attaching gear housing for
the guard release lever to operate
properly.
6. Attach proper dust collection guard with
foot and accessory.
INSTALLING MASONRY TYPE 1
CUTTING GUARD
1. Use tool adjusted as show in figures 9
and 10.
2. Disconnect battery pack from tool.
3. Unscrew and remove side handle.
4. Slide dust extraction guard on spindle
neck.
5. Rotate attachment until stability bracket
and hole for side handled are aligned.
A type 27 grinding wheel
guard may not be used
Assembly
FIG. 9
FIG. 10
180
DEGREES
-19-
SPRING
GUARD
RELEASE
LEVER
(x3)
SLIDE
SWITCH
4x
180
DEGREES