Husqvarna HG 125 B Original Instructions Manual page 17

Sanding Accessories
Assembly
BACKING PAD
maximum safe operating speed is not
exceeded by the nameplate speed of the
tool.
operations. Always reinstall wheel guard
when converting back to grinding operations.
backing pad for sanding accessories.
TO INSTALL BACKING PAD AND
SANDING DISC (Not Included)
Disconnect battery pack from tool.
Set the tool on its top side (spindle up).
Place the rubber backing pad onto the
spindle shaft. Center the sanding disc on
top of the backing pad. Insert the lock nut
through the disc and thread onto the
spindle as far as you can with your fingers.
Press in the spindle lock, then tighten the
backing pad securely with lock nut wrench
(Fig. 6).
TO REMOVE: Reverse procedure.
WIRE CUP BRUSH ASSEMBLY
Disconnect battery pack from tool. Wire cup
brushes are equipped with their own
threaded hub, simply thread on to spindle.
Be sure to seat against shoulder before
turning tool "ON".
TO REMOVE: Reverse procedure.
WIRE WHEEL ASSEMBLY
Disconnect battery pack from tool. Install
type 27 guard (Fig. 7). Wire wheels are
equipped with their own threaded hub,
simply thread on to spindle. Be sure to seat
against shoulder before turning tool "ON".
TO REMOVE: Reverse procedure.
Before attaching
backing pad be sure its
Wheel guard may not be
used for most sanding
Do not use the Quick-
Clamping Nut
Assembly
FIG. 6
a
SPINDLE
with
FIG. 7
SPINDLE
-17-
(not included)
LOCK NUT
(not included)
WIRE CUP BRUSH
WIRE WHEEL
BACKING
PAD
SANDING
DISC
TYPE 27
WHEEL
GUARD