Table of Contents
Advertisement
Clearing Entries and List Elements
Clearing Entries and List Elements
Clearing Entries and List Elements
Clearing Entries and List Elements
Clear Entries
Clear Entries
Clear Entries
Clear Entries
clears the contents of the
Clear Entries
To clear the
ENTRY
1. Press y L to display the
2. Select
3:Clear Entries
3. Press Í to clear the
To cancel
Clear Entries
If you select
Note:
pasted to the program editor, and the
executed.
ClrAllLists
ClrAllLists
ClrAllLists
ClrAllLists
sets the dimension of each list in RAM to
ClrAllLists
To clear all elements from all lists, follow these steps.
1. Press y L to display the
2. Select
4:ClrAllLists
Chapter 18: Memory and Variable Management
storage area, follow these steps.
MEMORY
to paste the instruction to the home screen.
storage area.
ENTRY
, press '.
from within a program, the
3:Clear Entries
MEMORY
to paste the instruction to the home screen.
(last entry on home screen) storage area.
ENTRY
menu.
(last entry) is cleared when the program is
Entry
.
0
menu.
instruction is
Clear Entries
521
- Quick Links:
- Using 2Nd/Alpha Keys
- Turning On/Off
- Batteries
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TI-84 Plus and is the answer not in the manual?
Questions and answers
My TI84 plus CE will not convert a decimal to a fraction. I hit the math key and press 1 for FRAC. I get a ANS/FRAC notification. Then I press enter again and it continues to justs give the decimal as the answer. I **** in Normal Float Auto Real Radian MP modes. I have watched numerous videos and followed these instructions but get the same result...the repeated decimal. Can you please help?
Your TI-84 Plus CE may not be converting a decimal to a fraction due to mode settings or order of operations. Ensure MATHPRINT mode is enabled and check if you are using the correct key sequence:
Press [.] [number] [ALPHA] [F1] [4] [ENTER].
If the issue persists, verify that the calculator is not set to a mode that forces decimal output. You may also need to adjust settings in the [Mode] menu to ensure fractions are displayed correctly.
This answer is automatically generated
Will they work without batteries? Are they chareable
The Texas Instruments TI-84 Plus does not work without batteries. It uses 4 AAA alkaline non-rechargeable batteries and has an SR44SW backup battery to maintain settings during battery replacement. It is not rechargeable, and its USB port is only for communication, not charging.
This answer is automatically generated