Remote Controller - Kenwood DMX7522DABS Instruction Manual

Monitor with receiver

Hide thumbs

Table Of Contents

Table of Contents

Settings

Repeat steps 2 and 3 to register other

buttons.

Touch [Done] to finish the procedure.

• The unit can register all of the buttons' functions at

the same time. To do this, press all buttons in turn

and after pressing all of them, touch [Done] on the

<Steering Remote Controller Setting> screen.

However, new functions cannot be learned after this

operation.

To change the previously assigned function:

① Touch the key to change on the <Steering Remote

Controller Setting> screen.

② Select a new function to assign from the function

list.

③ Touch [Done] to finish the procedure.

To initialise the setting: Touch [Initialise] for

<Steering Remote Controller>.

A confirmation message appears. Touch [Yes].

• To cancel the initialisation, touch [No].

ENGLISH

Update the system by connecting a USB device

containing an update file.

• To obtain the update file, visit

<https://www.kenwood.com/cs/ce/>.

Connect a USB device with the update file to the unit.

System Information

Application Version

Vxxx

Update

System Version

Vxxx

Update

GNSS Version

Vxxx

Update

DAB Module Version

Vxxx

Update

Update starts. It may take a while. If the update has

been completed successfully, "Update Completed.

Please switch ignition off" appears.

Updates the system application.

Updates the system.

Updates the Global Navigation Satellite firmware.

Updates the Digital Audio Broadcast (DAB) module

application.

• Do not disconnect the USB device while updating.

• If the update has failed, turn the ignition switch off

then on, and retry the update.

Shows the Open Source Licenses.