Remote Controller; Preparation - Kenwood DDX719WBLT Instruction Manual

Monitor with/without dvd receiver
Table of Contents

Advertisement

Remote Controller

Remote Controller
This unit can be operated using the remote controller
(RC-DV340) supplied with this unit.
Point the remote controller directly at the remote
sensor on the monitor panel.
DDX719WBTL/DMX719WBTL
DDX6019BT/DMX6019BT
DMX5019BT
* Remote sensor: DO NOT expose the remote sensor to bright light
(direct sunlight or artificial lighting).
44
ENGLISH
CAUTION
• Put the remote controller in a place where it will
not move during braking or other operations. A
dangerous situation could result if the remote
controller falls down and gets wedged under the
pedals while driving.
• Do not leave the battery near fire or under direct
sunlight. A fire, explosion or excessive heat
generation may result.
• Do not recharge, short, break up or heat the battery,
or place it in an open fire. Such actions may cause
the battery to leak fluid. If spilled fluid comes in
contact with your eyes or clothing, immediately rinse
with water and consult a physician.
• Place the battery out of reach of children. In the
unlikely event that a child swallows the battery,
immediately consult a physician.

Preparation

Battery installation
Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and – poles aligned
properly, following the illustration inside the case.
• Always insert batteries from – poles to avoid bending
the springs.
• If the remote controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted. In such instances, replace
both batteries with new ones.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ddx6019btDmx719wbtlDmx6010btDmx5019bt

Table of Contents