Adjusting The Self-Propel Drive - Toro 21864 Operator's Manual

Adjusting the Self-Propel
Drive
For Self-Propel-Drive Models Only
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1. Turn the adjustment nut counterclockwise to
loosen the cable adjustment
Figure 22
1. Handle (left side)
2. Adjustment nut
3. Self-propel-drive cable
2. Adjust the tension on the cable
pulling it back or pushing it forward and holding
that position.
Note:
Push the cable toward the motor to
increase the traction; pull the cable away from
the motor to decrease the traction.
3. Turn the adjustment nut clockwise to tighten the
cable adjustment.
Note:
Tighten the nut firmly with a socket or
wrench.
(Figure 22).
g269307
4. Turn the nut clockwise to
tighten the adjustment.
5. Turn the nut
counterclockwise to
loosen the adjustment.
(Figure 22) by
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Contact your local municipality or your authorized Toro
distributor for more information on how to responsibly
recycle the battery.
21