Encoder Assembly (Circuit Board Replacement); Bracket Attachment (Correct Attachment Of Power Arms); G.wiring Diagram List - Horton 2000B Series Setup Instructions & Troubleshooting

APPENDIX E ENCODER ASSEMBLY
Disassemble the encoder as shown
to replace the circuit board.
C3960
NOTE: 2001
C3675 ENCODER
IS SIMILAR.
C310
C3755-1
1st Step
Extract the grommet from the cap
and remove the screws.
4th Step
Replace the circuit board and reassemble the encoder .
NOTE: Run the initialization learn cycle (see sect. 2 ) after replacing the board.
APPENDIX F BRACKET ATTACHMENT
If the unit has been disassembled for painting or other reasons, the power brackets
MUST be reattached as shown.
C5655
C3964
2nd Step
Remove the cap while
pushing the wire in.
C5649
C9872-1
C9668
3rd Step
C5647
Disconnect the wiring.
Remove the center screw and
encoder disk.
Remove the spacers and the
circuit board.
On a bipart unit the right
bracket must be attached
to the lower belt & the
left bracket attached to
the upper belt.
On single slides a left hand slide will
attach to the top belt & a right hand
slide will attach to the bottom belt.
APPENDIX G WIRING DIAGRAM LIST
DRAWING
No. BEAMS
X
11100.0
X
11100.1
X
11101.1
X
11104.1
X
11105.0
X
11107.0
C3967 X
11228.0
11229.0
11231.0
11232.0
X
11247.0
X
11249.1
KEY SW
ACTIVATE
X
X
X X
X X X
X
X
X
X X
X X
X
X
X X
AUTO-
LOCK
5 Position SW
X Security panel C1280
X
X
C3881 w/ mag lock
Security panel C1280
Limited access