Ornament L Assy (L-Ch) - Sony WH-1000XM4 Service Manual

WH-1000XM4
Ver. 1.1

2-14. ORNAMENT L ASSY (L-ch)

Note 1: When installing the ornament L assy, refer to "2-15. HOW
TO INSTALL THE ORNAMENT L ASSY" on page 38.
– L-ch –
Turn around.
2 Open the ornament (L) block
in the direction of the arrow.
37
housing block (L-ch)
1 two tapping screws P2
(L = 8.0 mm) (silver)
(See Fig. W)
1 two tapping screws P2
(L = 8.0 mm) (silver)
(See Fig. W)
Note 2: The DMIC module is connected.
Do not pull the ornament (L) block
with excessive force.
Note 3: Do not touch sealing UV bond.
ornament (L) block
MAIN L board
• Note when removing the screws
< Fig. W >
There are only four screws (silver color) required to
remove the ornament (L) block as shown in the figure
below. Do not remove the other screws.
– L-ch
3 Draw the DMIC module out of
the connector in MAIN L board.
NFC wire
(UEWX2)
NFC L board
5 Peel the adhesive NFC off
6 adhesive NFC
Note 4: When the NFC L board is removed from the ornament L assy,
make sure to replace the adhesive NFC with a new one.
Sony CONFIDENTIAL
For Authorized Servicer
screw to remove
(silver color)
screw to remove
(silver color)
–
Note 3: Do not touch sealing UV bond.
rib
4 Remove the NFC wire
(UEWX2) from the rib.
7 ornament L assy
of the ornament L assy.
SYS SET