Table of Contents
Advertisement
Indoor Unit Installation
NOTICE
NOTICE
Panel installation should be performed after
wiring and piping have been completed.
Before Installation
• Determine the route to move the unit to the
installation site.
• First unseal and unpack the unit. Then, hold
the seats of the hanger (4 pcs) to move the
unit. Refrain from exerting force on other parts
of the unit, especially the refrigerant piping,
water discharge piping, and the plastic parts.
Step 1: Select installation location
Before installing the indoor unit, you must
choose an appropriate location. The following
are standards that will help you choose an
appropriate location for the unit.
Proper installation locations meet the
following standards:
Enough room exists for installation and
√
maintenance.
Enough room exists for the connecting the
√
pipe and drainpipe.
Installation place
＞500mm(19.69 in)
Page 20
The ceiling is horizontal and its structure can
√
sustain the weight of the indoor unit.
The air inlet and outlet are not blocked.
√
The air ow can ll the entire room.
√
There is no direct radiation from heaters
√
DO NOT install unit in the following
locations:
Areas with oil drilling or fracking
Coastal areas with high salt content in the
air
Areas with caustic gases in the air, such as
hot springs
Areas that experience power uctuations,
such as factories
Enclosed spaces, such as cabinets
Kitchens that use natural gas
Areas with strong electromagnetic waves
Areas that store ammable materials or gas
Rooms with high humidity, such as
bathrooms or laundry rooms
Roof
Ceiling hole
(unit: mm/inch)
＞500mm(19.69 in)
Advertisement
Table of Contents
