Wall Installation; Figure 2.7 Wall Installation (1); Figure 2.8 Wall Installation (2); Figure 2.9 Wall Installation (3) - Samsung OfficeServ 7200 Installation Manual

CHAPTER 2. Ошибка! Используйте вкладку "Главная" для применения 제목 1 к тексту, который должен здесь
отображаться.

2.4.2 Wall Installation

The procedure for installing the OfficeServ 7200 cabinet on a wall by using a wall bracket
is as follows:
1) There are four screw holes (A in Figure 2.7) on the wall bracket as shown below.
Mark the four screw holes where the wall bracket should be installed.
2) Use the electrical drill to make holes where the screw holes were marked. The depth of
the hole should be over 35 mm and the diameter should be about 5.5 mm so that the
plastic anchor can be easily inserted.
3) Using a hammer, insert the plastic anchor into the hole.
2-6
A
A

Figure 2.7 Wall Installation (1)

Figure 2.8 Wall Installation (2)

Figure 2.9 Wall Installation (3)

© SAMSUNG Electronics Co., Ltd.