Replacing the supplies
0.
Media
This section explains the procedure for replacing media with new media of the same type and the same width.
Use Toshiba Tec Corporation certified genuine media.
Open the top cover.
1
Immediately after printing, do not touch the print head or its surrounding area.
This could cause burns.
While holding the holder lock lever [1], extend the media holder [2] to the right and left.
2
3
Remove the core or the remaining portion of the media.
Place the new roll media [1] between the right and left parts of the media holder [2] so that the
4
print side will face upward.
[ 1 ]
[ 2 ]
[ 4 ]
Pay attention to the rolling direction of the media when loading the media. If you load the media in the
opposite direction, printing fails.
Cut the end of the media straight with scissors. For labels, cut the base between labels straight.
When loading media, be careful not to damage the media damper (top) [3] and the media damper (bottom)
[4].
While holding the holder lock lever [1], slide the right and left parts of the media holder [2]
5
inward to lock the roll media firmly. Confirm that the convex portions of the core holder [2] fit
the core.
[ 2 ]
90 Replacing the supplies
[ 2 ]
[ 1 ]
[ 3 ]
[ 2 ]
[ 2 ]
[ 1 ]