Cleaning The Milk Container; Cleaning The Hot Water/Steam Connection Nozzle; Descaling - DeLonghi 23 Series Instructions For Use Manual

Please note:
If the infuser is difficult to insert, before insertion, squeeze the
two levers shown in the figure to make it smaller.
8. Once inserted, make sure the two red buttons have
snapped out.
9. Close the infuser door.
10. Replace the water tank.

Cleaning the milk container

Clean the milk container each time you prepare milk as
described below:
1. Remove the lid.
2. Remove the milk spout and intake tube.
3. Turn the froth adjustment
dial clockwise to the "INSERT"
position (see figure) and pull
off upwards.
4. Wash all the components
thoroughly with hot water
and mild washing-up liquid.
All components are dishwasher
safe, placing them in the top
basket of the dishwasher. Make
sure there are no milk residues
on the hollow and groove under
the dial (see figure alongside).
If necessary, scrape the groove
with a toothpick.
5. Rinse inside
adjustment dial seat with
running water (see figure)
6. Check that the intake tube and
spout are not clogged with
milk residues.
7. Replace the
correspondence to the word
"INSERT"), spout and milk
intake tube.
8. Place the lid back on the milk
container.
Cleaning the hot water/steam
connection nozzle
Each time you prepare milk, clean
the connection nozzle with a sponge to remove milk residues
from the gaskets (fig. 23).

DESCALING

Descale the machine when the message "DESCALE" flashes on
the display.
Important!
• Descaler contains acids which may irritate the skin
and eyes. It is vital to follow the manufacturer's safety
warnings given on the descaler pack and the warnings
relating to the procedure to follow in the event of contact
with the skin and eyes.
• You should use De'Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may
result in faults not covered by the manufacturer's
guarantee.
1. Turn the machine on.
2. Press the P button to enter the menu.
3. Turn the selection dial until "Descale" is displayed.
4. Select by pressing the
displayed. Press
5. The message "Add descaler Confirm?" is displayed,
alternating with "EMPTY THE DRIP TRAY" and "REMOVE
FILTER" (if the filter is present).
6. Empty the water tank (A9) completely and remove the
water softener filter (if present). Empty the drip tray (fig.
24) and grounds container, then put them back in the
appliance.
7. Pour the descaler into the tank up to level A (corresponding
to a 100 ml pack) marked on the side of the tank (fig. 30),
then add water (1 litre) up to level B (fig. 30) and put the
water tank back.
16
the froth
dial (in
button: "Descale Confirm?" is
again to enable the function.