Advertisement
2.
INTRODUCTION
Compact, lightweight cordless drill/driver with added hammer function. Comfortable composite housing with soft grip to reduce vibration.
Ø0.8-10mm Keyless chuck. 2-Speed settings and 21 torque settings provide the control required to complete various tasks. All metal
gear construction for ultimate durability and performance. Integral LED battery level indicator and LED worklight. Supplied with belt hook
for safer storage while not in use. Requires Model No. CP1200BP 12V 1.5Ah Lithium-ion Battery and Model No. CP1200MC Battery
Charger.
3.
SPECIFICATION
Model No: .......................................................... CP1201
Battery Options (not included): ..... 12V 1.5Ah Lithium-ion
........................................................ 12V 3Ah Lithium-ion
........................................................ 12V 4Ah Lithium-ion
Chuck Size: ........................................................ Ø10mm
Drilling Capacities: ................................. Wood - Ø20mm
................................................................Metal - Ø10mm
..........................................................Concrete - Ø10mm
Impact Rate:.................................... 0-6000/0-19500bpm
Maximum Torque: ...................................................25Nm
Noise Power/Pressure: ................................. 80/69dB(A)
No-Load Speed: ...................................0-400/0-1300rpm
Replacement Parts:............ CP1200MC - Mains Charger
Vibration/Uncertainty: .................................... 9.6/1.5m/s²
4.
OPERATION
4.1.
USING THE DRILL
4.1.1. Ensure the direction selector (fig.1) is in the mid (lock) position.
4.1.2. Open the chuck by turning the rear chuck collar.
4.1.3. Insert the required drill or screwdriver bit into the chuck fully and tighten.
4.1.4. The speed range of the drill is controlled by the speed selector on top of the casing (high for drilling, low for screwdriving)
4.1.5. Select clockwise or anticlockwise direction by means of the direction selector.
4.1.6. Select the required screwdriver / Drill / Hammer setting by turning the Hammer selector ring.
4.1.7. Select the required screwdriver torque by turning the torque selector ring. The torque increases from 1-21.
4.1.8. Squeeze the trigger to start the drill; initial pressure switches on the LED worklight, further pressure starts the motor and increases
speed.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic
Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact
your local solid waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When
the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved
containers and dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.1
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
CP1201
Issue 4 (ALL)
REGISTER YOUR
PURCHASE HERE
13/06/23
Advertisement
