Table of Contents
Advertisement
Using the Fuel-Shutoff
Valve
The fuel-shutoff valve is located under the seat. Move
the seat forward to access it.
Close the fuel-shutoff valve for transport, maintenance,
and storage.
Ensure that the fuel-shutoff valve is open when
starting the engine.
Figure 37
1. O
position
N
Using the
Drive-Wheel-Release
Valves
WARNING
Hands may become entangled in the rotating
drive components below the engine deck,
which could result in serious injury.
Shut off the engine, remove the key, and allow
all moving parts to stop before accessing the
drive-wheel-release valves.
WARNING
The engine and hydraulic-drive units can
become very hot. Touching a hot engine or
hydraulic-drive units can cause severe burns.
Allow the engine and hydraulic-drive units
to cool completely before accessing the
drive-wheel-release valves.
g008948
2. O
position
FF
The drive-wheel-release valves are located in the
back of each hydraulic-drive unit, under the seat.
Note:
Make sure that the release valves are in the
fully horizontal position when operating the machine
or severe damage to the hydraulic system can occur.
1.
Disengage the blade-control switch (PTO), turn
the ignition key to the O
levers to the N
parking brake, and remove the key.
2.
Rotate the release-valve levers vertically to push
the machine
(Figure
Note:
This allows hydraulic fluid to bypass the
pump enabling the wheels to turn.
3.
Disengage the parking brake before pushing
the machine.
1. Vertical to push the
machine
4.
Rotate the release-valve levers horizontally to
run the machine
Loading the Machine
Use extreme caution when loading or unloading
machines onto a trailer or a truck. Use a full-width
ramp that is wider than the machine for this procedure.
Back up the ramp and drive forward down the ramp
(Figure
39).
34
position, move the
FF
-
position, engage the
EUTRAL
LOCK
38).
Figure 38
2. Horizontal to run the
machine
(Figure
38).
g008957
Advertisement
Table of Contents
