National Instruments NI 9792 User Manual And Specifications page 13

3. Insert the NI-WSN software installation disc into the drive on your computer.
4. Follow the onscreen instructions to install the NI-WSN software and NI MAX.
Note The NI Wireless Sensor Network Getting Started Guide is available after installation
from Start»All Programs»National Instruments»NI-WSN.
Make sure the NI 9792 device power is disconnected.
5. Attach a ring lug, as shown in Figure 9, to a 14 AWG (1.6 mm) wire. Connect the ring lug to the
ground terminal on the bottom of the device using the ground screw. Attach the other end of the
wire to the system ground.
1 Ring Lug Attached to the Ground Screw with Cable Attached
NI 9792 WSN Real-Time Gateway User Guide and Specifications
Figure 9. Ring Lug Attached to the Ground Screw
12
1
ni.com