Rohde & Schwarz CMW 500 Operating Manual page 360

®
R&S CMW 500
FETCh:WCDMa:MEAS<i>:MEValuation:STATe?
Queries the main measurement state; see
FETCh:...:MEAS<i>:...:STATe:ALL? to query the measurement state including
the substates. Use INITiate..., STOP..., ABORt... to change the
measurement state.
Returned values:
<Main State>
Example
Characteristics
FETCh:WCDMa:MEAS<i>:MEValuation:STATe:ALL?
Queries the main measurement state and the
measurement substates are relevant for running measurements only. Use
FETCh:...:MEAS<i>:...:STATe? to query the main measurement state only. Use
INITiate..., STOP..., ABORt... to change the measurement state.
Returned values:
<Main State>,
<Sync State>,
Operating Manual 1202.3986.32 – 03
Measurement
OFF: measurement switched off, no resources allocated, no
results available (when entered after STOP...)
RDY: measurement has been terminated, valid results may be
available
RUN: measurement running (after INITiate..., READ...),
synchronization pending or adjusted, resources active or queued
(see Measurement Substates)
Def. value: OFF
See Performing Single Shot Measurements
Firmware version V1.00
SCPI: Query only
OFF: measurement switched off, no resources allocated, no
results available (when entered after STOP...)
RDY: measurement has been terminated, valid results may be
available
RUN: measurement running (after INITiate..., READ...),
synchronization pending or adjusted, resources active or queued
(see Measurement Substates)
Def. value: OFF
PEND: waiting for resource allocation, adjustment, hardware
switching ("pending")
ADJ: all necessary adjustments finished, measurement running
("adjusted")
INV: not applicable because <main_state>: OFF or RDY
("invalid")
WCDMA Applications
WCDMA Command Reference
Control. Use
measurement substates. Both
340