page 26.
ECM00051
CAUTION:
Do not continue to run the engine if the
overheat-warning indicator is on. Serious
engine damage will occur.
1
1. Overheat-warning indicator
EMU26601
Speedometer (digital type)
This gauge shows the boat speed.
1. Speedometer
2. Fuel gauge
3. Trip meter/clock/voltmeter
4. Warning indicator(s)
NOTE:
After the main switch is first turned on, all
segments of the display come on as a test.
After a few seconds, the gauge will change
to normal operation. Watch the gauge when
turning on the main switch to make sure all
segments come on.
NOTE:
The speedometer displays km/h, mph, or
knots, according to operator preference. Se-
lect the desired units of measurement by set-
ting the selector switch on the back of the
gauge. See the illustration for settings.
ZMU01868
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26610
Trim meter
This gauge shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired setting with the
Basic components
ZMU04581
23