Choke Switch; Throttle Friction Adjuster; Engine Shut-Off Switch - Yamaha 115 Owner's Manual

1. Fully open
2. Fully closed
EMU26221

Choke switch

To activate the choke system, press in the
main switch while the key is turned to the
" " (on) or "
choke system will then supply the rich fuel
mixture required to start the engine. When
the key is released, the choke will switch off
automatically.
EMU25971

Throttle friction adjuster

A friction device provides adjustable resis-
tance to movement of the throttle grip or the
remote control lever, and can be set accord-
ing to operator preference.
To increase resistance, turn the adjuster
clockwise. To decrease resistance, turn the
" (start) position. The
ZMU03160
Basic components
adjuster counterclockwise.
EWM00031
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to move the remote control lever
or throttle grip, which could result in an
accident.
When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
EMU25991

Engine shut-off switch

The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power.
EWM00121
WARNING
Attach the engine shut-off cord to a se-
G
cure place on your clothing, or your
arm or leg while operating.
Do not attach the cord to clothing that
G
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-
G
17