Table of Contents
Advertisement
Appendix
Preparing Terminals
Preparing a Cord End Terminal
(1) Cable
Preparing an OT Terminal
(1) Cable
(4) Hydraulic pliers
Preparing PV Input Terminals
•
A PV-CZM-41100 crimping
tool is recommended.
Ensure that the cable
•
cannot be pulled out after
being crimped.
Use the wrench shown in
•
the figure to tighten the
locking nut. When the
wrench slips during the
tightening, the locking nut
has been tightened.
(2) Cord end terminal
(2) OT terminal
(5) Heat gun
31
(3) Crimping tool
(3) Heat-shrink tubing
Advertisement
Table of Contents
