Table of Contents
Advertisement
Cautions for Installation
Observe the following safety instructions when installing the system.
Before Installing
The system must be installed close to a window or wall to face a guided direction
to a 5G signal.
The location of the CPE allows at least 20 cm (about 8 inches) between the unit
and persons to be compliance with FCC RF exposure guidelines.
The location of the CPE is 10 feet away from the products that generate
electromagnetic radiation (e.g. microwave oven).
It is recommended that the product installation to be performed by a competent
and trained professional.
While Installing
•
•
Make sure the power switch for the power supply is off when installing the system.
Installing the system with the power switch on may cause system damage or fatal
human injury when cables are not correctly connected.
Do not wear accessories such as watches and rings in order to prevent electrical
shock.
After Installing
Remove any debris produced during the work and clean up the installation site.
Make sure the worker does not damage the installed cables while cleaning the
system.
While cleaning the power supply device, take caution that the device does not
come in contact with foreign objects that may cause power failure.
5G Indoor CPE Installation Manual
Copyright © 2018, All Rights Reserved.
The system power must be cut off before installing.
Be careful not to damage or scratch the system and the cables among the
boards when the system is transported or installed.
Confidential
5
Advertisement
Table of Contents
