Remove The Upper Case (With Keyboard); Disassemble The Lcd Unit - Lenovo ThinkBook 14s Gen 2 Hardware Maintenance Manual

Figure 79. Remove six screws and remove the LCD unit
Screw specifications
M2.5 x L5

Remove the upper case (with keyboard)

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 58
"Remove the battery pack" on page 59
"Remove the solid-state drive (SSD) module" on page 59
"Remove the heat sink" on page 60
"Remove the fans" on page 61
"Remove the I/O bracket (right)" on page 63
"Remove the I/O bracket (left)" on page 64
"Remove the I/O board" on page 65
"Remove the fingerprint board module" on page 66
"Remove the speakers" on page 67
"Remove the touchpad with cable" on page 68
"Remove the system board and the I/O board cable" on page 69
"Remove the LCD unit" on page 71
Go to
https://support.lenovo.com/partslookup
part:
Upper case (with keyboard)

Disassemble the LCD unit

The LCD unit as a whole is not an FRU. Instead, it contains FRUs as its components. Before disassembling
the LCD unit, make sure it has been detached from the upper case.
72
Hardware Maintenance Manual
Number of screws
6
to look up the Lenovo part number of the following replacement