Remove The I/O Bracket (Right) - Lenovo ThinkBook 14s Gen 2 Hardware Maintenance Manual

Remove the I/O bracket (right)

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 58
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Peel off the tape and release the antenna cable from the cable guide.
Figure 60. Peel off the tape and release the antenna cable from the cable guide
Step 3. Remove three screws and then open the hinge.
Figure 61. Remove three screws and then open the hinge
Screw specifications
M2.5 x L5
Step 4. Remove two screws and then remove the I/O bracket (right).
Number of screws
3
.
Chapter 4 Removing a FRU or CRU
63