Mitsubishi Electric JT-MC106G-W-NA Handbook page 17

Assembly precautions
• Run the lead wires through the groove of the blower cover.
(Indicated by )
• Take care not to pinch the lead wires.
• After installing the circuit board, make sure that the LEDs are
upright.
Assembly precaution
Run the lead wires through the claw of the blower case. (Indicated
by )
(3) Sensor circuit board (JT-33S)
1 Remove the panel (assembly).→ See (2) 1 to 3.
2 First, remove the protector sheet, and unhook the claw of the fix plate
from the nozzle (indicated by
3 Remove the sensor circuit board (JT-33S).
Assembly precautions
• Run the lead wires through the groove of the nozzle. (Indicated by
)
• Take care not to pinch the lead wires.
• After installing the sensor circuit board, make sure that the LED is
upright.
), and then remove the fix plate.

─ 17 ─
Protector sheet
Fix plate
(under the protector sheet)
Sensor circuit board (JT-33S)