Mitsubishi Electric JT-MC106G-W-NA Handbook page 10

(5) Operating procedures for the test mode: indicating the number of operation/
operating time
1 How to start the test mode: Turn ON the power while holding down both of the heater switch and sensor
2 Lighting status of the heater light shows the contents of the indication.
• The heater light ON : The cumulative number of operation of the blower
• The heater light OFF : The cumulative operating time of the blower
Use the heater switch to switch between ON and OFF.
3 The sensor lights (ON and OFF) and check lights (1 and 2) indicate the cumulative number of operation.
• Display digit: A 4-digit display ( Check light 2 (LED 6) indicates a hundred-thousands digit, check light 1
• Display range: 100 to 999900 times
• Display method: The number of blinking (ON for 0.2 seconds/OFF for 0.2 seconds) of each light indicates
4 The sensor lights (ON and OFF) and check lights (1 and 2) indicate the cumulative operating time.
• Display digit: A 4-digit display ( Check light 2 (LED 6) indicates a thousands digit, check light 1 (LED 5)
• Display range: 1 to 9999 hours
• Display method: In the same way as described above. (See examples 1 and 2.)
Example 1: In the case of 999900 times or more, or 9999 hours of more
Check light 2
Check light 1
OFF light
ON light
Example 2: In the case of 246800 times, or 2468 hours
Check light 2
Check light 1
OFF light
ON light
Example 3: In the case of 100 times or less, or 1 hour or less
Power light: Fast blinking (ON for 0.1 seconds/OFF for 0.1 seconds)
ON light, OFF light, check light 1, and check light 2: OFF
5 During the test mode, the hand dryer only performs the above indication, and does not perform any other
operations including blowing air.
6 How to finish the test mode: Turn OFF the power, and wait for about 30 seconds. Turn ON the power again,
switch. At this time, the power light blinks fast (ON for 0.1 seconds/OFF for 0.1
seconds).
(LED 5) indicates a ten-thousands digit, OFF light (LED 4) indicates a thou-
sands digit, and ON light (LED 3) indicates a hundreds digit.)
the numeric value for each digit, and the pattern of blinking repeats in a 6-second cycle.
(See examples 1 and 2.)
indicates a hundreds digit, OFF light (LED 4) indicates a tens digit, and ON
light (LED 3) indicates a ones digit.)
2 3
1
1 2 3
1 2 3
1 2 3
(0.2 seconds + 0.2 seconds) × 9 = 3.6 seconds
1 2
1 2 3
1 2 3
1 2 3
and then the mode returns to the normal operation.
4 5 6
4 5 6
4 5 6
4 5 6
6.0 seconds
4
6
4 5
6
4 5 7
6.0 seconds
─ 10 ─
7 8 9
7 8 9
7 8 9
7 8 9
8
Repetition
Repetition