Rack Rails - Dell EMC PowerEdge MX7000 Field Service Manual

Rack rails

The MX7000 enclosure supports static rails.
Static rails features summary
Static rails do not support the ability to service the enclosure while in the rack and are not compatible with a CMA. A strain relief
bar (SRB) is provided with each rail kit to organize and secure the power cables exiting the back of the server.
Figure 67. Static rail
Static rails for 4-post racks
● Supports static rail installation.
● Supports tool-less installation in 19" EIA-310-E compliant square and unthreaded round hole 4-post racks, including all
generations of Dell racks. Does not support installation in threaded hole racks. Does not support installation in 2-post racks.
● MX7000 rails can be installed in a Dell EMC Titan or Titan-D rack
● Does not support extension of the enclosure out of the rack to enable serviceability of key internal components.
● Minimum rail mounting depth without the SRB depends on spacing between the front and rear mounting flanges of the rack.
Add amount below based on flange type:
○ Square hole (5.7 mm)
○ Round hole (11.8 mm)
● Minimum rail mounting depth with the SRB: 901
● Square-hole rack adjustment range: 592-876 mm
● Round-hole rack adjustment range: 578-869 mm
● Threaded-hole rack adjustment range: N/A
Field service information 59