Related Manuals for Uni-Mig ARC 170DC
Summary of Contents for Uni-Mig ARC 170DC
- Page 1 Page 1 Instruction Manual for ARC 170DC (W164) 15/12/2014 INSTRUCTION MANUAL ARC 170DC DC TIG & ARC Inverter Welder (240V) 10-170A W164...
- Page 2 Page 2 Instruction Manual for ARC 170DC (W164) 15/12/2014 YEARS Warranty Machine Model Description Part Number ARC - DC/MMA/TIG KUMJR140 / 170 CONTENTS PAGE No: Safety General Description Curcuit Diagram Main Parameter Pre-Cautions Operation Maintenance Trouble Shooting DECLARATION OF CONFORMITY...
- Page 3 Page 3 Instruction Manual for ARC 170DC (W164) 15/12/2014 SAFETY Welding and cutting equipment can be dangerous to both the operator and people in or near the surrounding working area, if the equipment is not correctly operated. Equipment must only be used under the strict and comprehensive observance of all relevant safety regulations.
- Page 4 Page 4 Instruction Manual for ARC 170DC (W164) 15/12/2014 GENERAL DESCRIPTION & SAFEGUARDS This welding machine is manufactured with advanced inverter technology. The features of ARC 140/170 series are: Efficiency, energy saving, portability, excellent stable arc characteristics, relatively low no-load voltage, compensation of ARC force and LIFT ARC for DC TIG welding.
- Page 5 Page 5 Instruction Manual for ARC 170DC (W164) 15/12/2014 CIRCUIT DIAGRAM...
- Page 6 Page 6 Instruction Manual for ARC 170DC (W164) 15/12/2014 MAIN PARAMETER Machine Model Description Part Number Plasma Cut 40 KUMJR140 KUMJR170 Tecnical Specification Part Number KUMJR140 KUMJR170 Rated Input Voltage voltage 240 1 Phase 240V 1Phase Rated Input Power (KVA) Ieff (AMPS) 14.2A...
- Page 7 Page 7 Instruction Manual for ARC 170DC (W164) 15/12/2014 PRE-CAUTIONS 1. Working Environment. 1.1 The environment in which this welding equipment is installed must be free of grinding dust, corrosive chemicals, flammable gas or materials etc, and at no more than maximum of 80% humidity.
- Page 8 Page 8 Instruction Manual for ARC 170DC (W164) 15/12/2014 OPERATION (140DC Shown) 1.Connection of Input Cables Primary input cable is supplied with this welding equipment. Connect the primary input cable with power supply of required input voltage. Refer to data plate on machine for Input voltage, IMAX and IEFF.
- Page 9 Page 9 Instruction Manual for ARC 170DC (W164) 15/12/2014 OPERATION For DC TIG welding the TIG torch should be connected to the negative socket, and the workpeice should be connected to the positive socket. Please note that the use of welding leads over 5 metres in length will require increasing the diameter of welding cable used in order to maintain and improve the performance of voltage output.
- Page 10 Page 10 Instruction Manual for ARC 170DC (W164) 15/12/2014 MAINTENANCE WARNING: Exposure to extremely dusty, damp, or corrosive air is damaging to the welding machine. In order to prevent any possible failure or fault of this welding equipment, clean the dust at regular intervals with clean and dry compressed air of required pressure.
Need help?
Do you have a question about the ARC 170DC and is the answer not in the manual?
Questions and answers