Removing The Paddle Motor (M3); Removing The Front Alignment Motor (M4) - Canon Staple Finisher-R1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Front Alignment Motor (M4)

Removing the Paddle Motor (M3)

1) Remove the rear cover. 2) Remove the 2 screws and disconnect the connector, and then remove the paddle motor.
(Refer to page 4-7)

Removing the Front Alignment Motor (M4)

1) Remove the upper 2) Remove the 2 screws and disconnect the connector, and then remove the belt from the pully
processing tray unit. to remove the front alignment motor.
(Refer to page 4-12)
4 Parts Replacement and Cleaning Procedure > Motors > Removing the Front Alignment Motor (M4)
x2
x1
x2
x1
F-4-37
F-4-38
4-18
4-18