Removing The Lower Processing Tray Unit - Canon Staple Finisher-R1 Service Manual

4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Lower Processing Tray Unit

Removing the Lower Processing Tray Unit

1) Remove the upper processing tray unit
(front/rear).
(Refer to page 4-12)
2) Remove the finisher controller PCB.
(Refer to page 4-24)
4 Parts Replacement and Cleaning Procedure > Main Units > Removing the Lower Processing Tray Unit
3) Remove the 2 screws and disconnect the 4 connectors, and then release the harness from the harness
guide to remove the lower processing tray unit.
x2
x1
x3
x2
F-4-30
4-15
4-15