ABB Relion SAM600 Communication Protocol Manual page 45

1MRK 511 441-UEN Rev. C
IEDs, then the alternate port (backup link) will be placed between IED3 and IED4 (for representation
and this depends on the configuration).
If any of the link breaks in the loop, then the backup link will be activated. For example, if a link
between IED1 and IED2 fails, then the backup link is activated; IED2 and IED3 will continue to
receive messages from IED4.
IED1 IED1
IEC21000008 V1 EN-US
Figure 16:
In the topology shown in
to IED1 forms the second ring, Sw3-Sw4-IED8 to IED5 forms the third ring. If the root port is Sw1 and
if the priority of other switches is lesser than that of the IEDs, then the alternate port or the backup
link could be between Sw3 and Sw4, IED3-IED4, IED7-IED8 (for representation and this depends on
the configuration).
IED IED
IEC21000006 V1 EN-US
Figure 17:
In the topology shown in
to IED1 forms the second ring, Sw1-Sw2-IED8 to IED5 forms the third ring, Sw3-Sw4-IED12 to IED9
forms the fourth ring, and Sw3-Sw4-IED16 to IED13 forms the fifth ring. If the root port is Sw1 and if
the priority of other switches is lesser than that of the IEDs, then the alternate port or the backup link
could be between Sw3 and Sw4, IED3-IED4, IED7-IED8, IED11-IED12, IED15-IED16 (for
representation and this depends on the configuration).
Switchgear control unit SAM600-IO
Communication protocol manual
Sw1, root bridge
IED2 IED2
Main link
Backup link
Ring topology, single ring
Figure 17, there are three rings, Sw1 to Sw4 form one ring, Sw1- Sw2- IED4
Sw1, root bridge Sw2
IED IED IED IED
Main link
Backup link
Ring topology, three rings
Figure 18, there are five rings. Sw1 to Sw4 forms one ring, Sw1-Sw2-IED4
© 2017 - 2021 Hitachi Power Grids. All rights reserved
Sw2
IED3 IED3
Sw3
IED IED
IED IED IED IED
Rapid spanning tree protocol (RSTP)
IED4 IED4
Sw4
IED IED IED IED
Section 8
39