Table of Contents
Advertisement
Basic Installation and Operation Guide
RECEIVING, HANDLING/MOVING, AND UNPACKING
Receiving and Unpacking
Upon receipt of the equipment, do the following:
• All JK Series units are shipped in the vertical (upright) position and should be handled accordingly when received.
If the controller is not upright upon receipt, notify the carrier of possible damage. Upright the units as soon as
possible and immediately notify the nearest Toshiba representative.
• Carefully unpack the unit and make an immediate inspection for any concealed damage which might have
occurred during shipment. If damage is found, it should be noted with the carrier prior to accepting the shipment,
if possible. Report any damage immediately and file a claim with the freight carrier within 15 days of receipt.
• Verify that the starter description on your unit matches your purchase order. The starter information is located
on stickers in the medium voltage incoming compartment.
• Keep the equipment upright.
WARNING
CAUTION
Handling and Moving
Medium voltage controllers should be handled with
care to avoid damage to components, frame, and finish
(Fig. 1).
The capability of the moving equipment to handle the
weight of the controller shipping section should be
confirmed. The equipment should remain secured to
the shipping skid to prevent distortion of the frame
during moving and to minimize tipping. Extreme care
should be exercised during any movement and
placement operations to prevent dropping or tipping.
WARNING
Using a Forklift
A forklift truck may offer a more convenient method of
handling the controller. A safety strap should be used
when handling with a forklift. The ends of the forks should
not enter the bottom of an open-bottom enclosure.
TOSHIBA
Do not install or energize equipment that has been damaged.
Do not lay the equipment on its side or upside down.
Do not place any part of your
body beneath the equipment
being lifted. Improperly
secured equipment can fall or
tip over quickly and without
notice.
JK Series 720 Controllers
Fig. 1 Moving the Controller
1
Advertisement
Table of Contents
