Table of Contents
Advertisement
Electrical Requirements
The Santa Fe Advance90 plugs into a common grounded 115VAC outlet. The device draws 5.7 Amps at 80°F and 60%
RH. Locate the dehumidifier in an area where the cord's length (9') easily reaches a 115 VAC electrical outlet with a
minimum of 15 Amp circuit capacity. If used in an area that may become wet, a GFCI protected circuit is recommended.
The unit should not be used in areas prone to flooding. Consult local electrical codes for any further information.
An optional remote dehumidistat is available for use with the Santa Fe Advance90 and is to be located remotely from the
dehumidifier.
CAUTION!
ELECTRICAL SHOCK HAZARD: Electrical power must be present to perform some tests. These tests should be
performed by a qualified service person.
Wiring Schematic
4034052
12
Santa Fe Advance90 Installation & Operation Instructions
Santa-Fe-Products.com | 800.533.7533
- Quick Links:
- Changing the Filter
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Advance 90 and is the answer not in the manual?
Questions and answers
What is the setting for 40% on the dial
The 40% setting on the dial for the Santa Fe Advance 90 would set the dehumidifier to maintain a relative humidity of 40%. However, the recommended setting for most applications is between 45% and 55% RH. Setting it to 40% may result in the unit running for longer periods, especially in cooler rooms under 65°F, where it may be less effective.
This answer is automatically generated