Bagging The Clippings; Installing The Grass Bag; Removing The Grass Bag - Toro 250000001 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass
and leaf clippings from the lawn.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing
the Side Discharge Chute on page 13) before bagging
the clippings.
Warning
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.

Installing the Grass Bag

1. Raise and hold up
the rear door.
2. Remove the rear
discharge plug.
3. Route the starter rope around the lower rope
guide.
Note: The lower rope guide releases the starter
rope when you pull the recoil start handle.
1.
2.
m-8157
m-8182
3352-856 Rev B
12
4. Install the bag onto the door rod.
m-8158
5. Lower the rear door.
m-8169

Removing the Grass Bag

To remove the bag, reverse the steps above.
m-8159