Safety Instructions - ABB FEN-11 Quick Manual

2
Quick guide - FEN-11
Introduction
This manual contains the very basic information about installing the
FEN-11 Absolute Encoder Interface. For complete documentation see
FEN-11 Absolute Encoder Interface User's Manual (3AFE68784841
[English])

Safety instructions

WARNING! All electrical installation and maintenance work on the drive
must be carried out by qualified electricians.
The drive and adjoining equipment must be properly earthed.
Do not attempt any work on a powered drive. After switching off the
mains, always allow the intermediate circuit capacitors 5 minutes to
discharge before working on the frequency converter, the motor or the
motor cable. Lock out and tag out. Check (with a voltage tester) that the
drive is in fact discharged before beginning work.
These warnings are intended for all who work on the drive. Ignoring
the instructions can cause physical injury or death, or damage the
equipment.
For complete safety instructions see the drive manuals.
Compatibility
Absolute Encoders
• Sin/Cos incremental encoder, 1...65535 pulses / rev, supports
reference mark and Sin/Cos commutation signals
• Endat 2.1 with Sin/Cos signals (partially without Sin/Cos signals)
• Endat 2.2 with Sin/Cos signals (partially without Sin/Cos signals)
• Hiperface
• SSI with Sin/Cos signals (partially without Sin/Cos signals). Check
compatibility.
Quick guide - FEN-11
.